Installing in a
LinkSwitch Hub
Remove the blanking plate from the hub which is to receive the FDDI MIC
Media Module. The relevant manual will tell you where to find the plate.
1Keep the blanking plate in a safe place so that it can be replaced if the
FDDI MIC Media Module is removed.
2Holding the mounting panel, insert the edge connector end of the FDDI
MIC Media Module, with the header pins side down, into the rear of the
hub.
3Slide the FDDI MIC Media Module in carefully to engage in the slot and
push it fully home.
4Fix the mounting panel of the FDDI MIC Media M odule to the hub using
the two screws from the blanking plate.
Connection to the
FDDI Network
Remove the launcher-protecting device from the MIC connector. Either of
the two types of protector shown Figure 3 and Figure 4 may be
encountered.
Figure 3 Type A protector
Figure 4 Type B protector
Connect the MIC connector to the FDDI MIC Media Module's connector.
Push firmly home.
WARNING: Take care to keep the ends of the connectors clean. Wipe with
a tissue moistened with ethanol if necessary.