When the Module is installed you can configure it
through your Switch. Refer to the SuperStack 3 Switch
Implementation Guide and the Management Interface
Reference Guide supplied with your Switch for more
information.
When using the Module, note the following:
The ports only operate at 1000 Mbps.
The ports only operate in full duplex mode.
The Module is not hot-insertable.
The Module is not hot-swappable.
If you suspect a problem, carry out these steps before
contacting your supplier:
Ensure that the Module is correctly installed in the
Switch and that the three captive thumbscrews which
secure the Module are tightened with a suitable tool.
Ensure that the Switch in which the Module is fitted
is powered-up.
Ensure that the device at the far end of the link is
powered-up and operating correctly.
Check that all connectors on the fiber optic segment
are correctly engaged.
Clean the terminators by wiping them gently with a
clean tissue or cotton bud moistened with a little
ethanol. Dirty fiber terminators on the fiber optic
segment impair the quality of the light transmitted
through the cable.
For information about technical support, refer to
“Technical Support” on page 7.
The SuperStack 3 Switch 4900 Series 1000BASE-LX
Module has been designed to the following standards: Environmental
Physical
MANAGING THE MODULEMODULE RESTRICTIONS
PROBLEM SOLVING
TECHNICAL SPECIFICATIONS
Functional ISO 8802-3, IEEE 802.3, I EEE 802.3x, IEEE 802.3z, IEEE
802.1D, IEEE 802.1Q
Safety UL 1950, EN 60950, CSA 22.2#950, IEC 6 0950, IEC
825-1, EN 60825-1
EMC CISPRR 22 Class A, EN55022 Class A, FCC Part 15
Subpart B Class A, ICES-003 Class A, VCCI Class A,
AS/NZS 3548 Class A, CNS 13 438 Class A
Immunity EN 55024
Operating Temperature 0–40°C (32–104°F)
Storage Temperature -10 to +70°C (14–158°F)
Operating Humidity 10–95 % (relative humidity, non-condensing)
Power Consumption 35 W (watts) maximum
Standards EN60068 (IEC68)—various parts
Width 244 mm (9.61 in.)
Depth 150 mm (5.91 in.)
Height 46 mm (1.81 in.) or 1U
Weight 0.37 kg (0.82 lb)
4