SHARPENING CUTTING LINKS
Always wear safety gloves when handling saw chains.
Risk of cutting injury.
With manual or automatic shoutdown. The machine can be stopped manually without a stop clamp when sharpening is complete, or with a stop clamp as described below.
Activate Power on, switch 7
Start grinding motor only with switch 1.
Using profile stone 7, profile the grinding wheel for the type of chain to be sharpened, as shown in Figure H. Check with profile template 6.
Stop the grinding motor with switch 1.
Place the chain to be sharpened between chain rulers 8.
Pull the chain around by hand and check that it runs freely in the chain track.
Check also whether the chain has “double links”, that it does not have any burrs on the drive links and that it is not damaged.
NOTE: If there are double links, see the instructions for double links.
• Check that the grinding head | 5 | |
is square to the teeth. | ||
• Start the automatic system with |
| |
switch 2. |
| |
• With wingnut 6, set the correct |
| |
stroke for the chain to be | 4 | |
sharpened. | ||
• Set the approximate sharpening |
| |
depth with wheel 5. | 6 | |
• Set the approximate sharpening | ||
depth with wheel 4. |
| |
• Start the grinding motor only |
| |
with switch 1. |
| |
• Set the sharpening depth finely | 2 | |
with wheel 5. | ||
• Set the sharpening length finely | 8 | |
with wheel 4. | ||
• Stop the automatic system with | 20 | |
switch 2 and the motor with | 9 | |
switch 1. | ||
• Then fix clamp 9, see Fig F, | 1 | |
after the first or last sharpened | 7 | |
tooth. | ||
|
•Let the machine run one revolution to clamp 9. Fig F. Stop the machine against stop arm 20.
10
