Phaser® 7300 Color Printer

User Safety Summary

Your printer and the recommended consumable supplies have been designed and tested to meet strict safety requirements. Attention to the following notes will ensure the continued safe operation of your printer.

Electrical Safety

Use the power cord supplied with your printer.

Do not use a ground adapter plug to connect the printer to a power source receptacle that lacks a ground connection terminal.

Plug the power cord directly into a properly grounded electrical outlet. Do not use an extension cord. If you do not know whether an outlet is grounded, ask an electrician to check the outlet.

Warning

Avoid the potential of electrical shock by ensuring that the printer is properly grounded.

Do not place the printer where people may step on the power cord.

Do not place objects on the power cord.

Do not obstruct the ventilation openings. These openings are provided to prevent overheating of the printer.

Warning

Do not push objects into slots or openings on the printer. Making contact with a voltage point or shorting out a part could result in fire or electrical shock.

If you notice unusual noises or odors, switch off the printer power immediately. Disconnect the power cord from the electrical outlet. Call an authorized service representative to correct the problem.

The power cord is attached to the printer as a plug-in device at the back of the printer. In the event it is necessary to remove all electrical power from the printer, disconnect the power cord from the power receptacle.

Warning

Electrical products may be hazardous if misused.

Warning

For your protection, do not disable any internal safety locks or sensors.

Note

Leaving the printer on is recommended for optimum performance, and does not pose a safety hazard.

Copyright © 2002 Xerox Corporation. All Rights Reserved.

14

Page 17
Image 17
3D Connexion 7300 manual User Safety Summary, Electrical Safety