STEP 11: (SEE FIGURE 11)
•Move the attachment clutch lever on the dash panel to the disengaged (down) position.
•Place the clutch/idler assembly on the fl oor on the left side of the tractor.
•Attach the tractor's clutch cable to the cable bracket. Secure the cable housing guide (groove down) to the cable bracket using the original collar and a 5/64" hair cotter pin (DD).
•Place a spacer (LL) on the welded pin on the idler arm. Hook the end of the clutch cable spring over the pin and secure it with a 1/4" washer (P) and a 5/64" hair cotter pin (DD).
•Align cable bracket with welded pin and tighten the nut assembled in step 9.
5/64" HAIR 
COTTER PIN (DD)
1/4" WASHER (P) 
SPACER (LL)
5/64" HAIR
COTTER PIN (DD)
TRACTOR'S
CLUTCH CABLE
CABLE
BRACKET
FIGURE 11
ATTACH CLUTCH IDLER ASSEMBLY TO TRACTOR
STEP 12: (SEE FIGURE 12)
•Attach the clutch/idler assembly to the tractor frame. Hook the notched suspension arms onto the two shoulder bolts (M) assembled to the outside of the tractor frame. Lift the front of the assembly and attach it to the R.H. and L.H. hanger brackets using two pivot lock pins (GG) and 1/8" hairpin cotters (EE).
PIVOT LOCK PIN (GG) | L.H. HANGER |
|
| |
BRACKET |
| SHOULDER | ||
(use this hole) |
|
|
| BOLT (M) |
|
|
|
|
|
|
| 1/8" HAIRPIN |
|
|
|
| COTTER (EE) |
|
|
FIGURE 12 | VIEWED FROM LEFT SIDE |
STEP 13: (SEE FIGURE 13)
•Assemble the drive belt onto the engine pulley fi rst and then onto the large pulley on top of the clutch/ idler assembly. The belt must be placed inside the engine pulley belt keeper(s) and between the large pulley and the keeper bolt next to it.
IMPORTANT: Do Not assemble the "V" belt outside of the engine pulley keepers or outside of the keeper bolt next to the large pulley.
Go to step 48 on page 21.
CLUTCH/IDLER ASSEMBLY
ENGINE |
| ENGINE | |||
PULLEY | ENGINE | PULLEY | |||
KEEPER | KEEPER | ||||
PULLEY | |||||
|
|
|
| ||
|
|
|
|
| |
Left Side
of Tractor
IDLER |
|
PULLEY | KEEPER BOLT |
|
FIGURE 13 | VIEWED FROM UNDERNEATH |
10