THIS SECTION IS FOR TRACTORS WITH A MANUAL ATTACHMENT CLUTCH
If your tractor has an electric attachment clutch go to step 14 on page 11.
STEP 7: (SEE FIGURE 7)
•Attach the pulley (long end of hub facing down) and the large spacer (MM) to the hole shown in the clutch/ idler assembly. Use a 3/8" x
3/8" HEX LOCK NUT (Z) |
|
|
| 3/8" | ||||
|
|
| ||||||
3/8" LOCKWASHER (O) |
|
| WASHER (T) | |||||
| ||||||||
|
|
|
| |||||
PULLEY (NN) |
|
|
|
|
|
|
| LONG END |
|
|
|
|
| ||||
LARGE SPACER (MM) |
|
|
| OF HUB | ||||
|
|
|
|
|
|
|
| 3/8" X |
|
|
|
|
|
|
|
| HEX BOLT |
|
|
|
|
|
|
|
| (A) |
FIGURE 7
STEP 8: (SEE FIGURE 8)
• Attach the two suspension arms to the rear of the |
clutch/idler assembly using two 5/16" x 3/4" hex bolts |
(C) and 5/16" nylock nuts (Y) for each arm. Place the |
STEP 9: (SEE FIGURE 9)
•Attach the cable bracket to the slot shown in the clutch/idler assembly using a 5/16" x 3/4" carriage bolt (K) and a 5/16" nylock nut (Y). Place the bolt in the front hole of the bracket and in the end of the slot closest to the pulley. Do not tighten yet.
5/16" x 3/4"
CARRIAGE BOLT (K)
CABLE 
BRACKET
5/16" NYLOCK NUT (Y)
FIGURE 9
STEP 10: (SEE FIGURE 10)
•Two different length drive belts are included with your snow thrower. Tractors with manual attachment clutches and single front deck suspension brackets use the 56" drive belt with #48138 printed on the outside of the belt. DO NOT USE the other belt.
•Slightly loosen the hex bolt next to the fl at idler pulley. Install the drive belt down between the hex bolt and the
flat idler pulley with the fl at side of the belt against the pulley. Retighten the hex bolt.
Loop the belt around the large
arms on the outside of the frame with the notches to |
the rear. |
HEX BOLTS
(#48138)
DRIVE BELT
FIGURE 10
FLAT IDLER PULLEYS
5/16" NYLOCK | 5/16" x 3/4" | Did you select the correct drive belt for your |
NUT (Y) | HEX BOLT (C) | STOP tractor? Using the wrong length belt may |
FIGURE 8 |
| cause premature bearing or belt failure. |
|
|
9