TOOLS REQUIRED FOR ASSEMBLY
(2)7/16" Wrenches
(2)1/2" Wrenches
(2)9/16" Wrenches
(2)3/4" Wrenches
(1)Screw Driver
(1)Knife
ADDITIONAL ITEMS REQUIRED
General Purpose Grease
ASSEMBLY
IDENTIFYYOU TRACTOR
STEP 1: (SEE FIGURE 1)
•Look under the front of your tractor. If there is a single mower deck suspension bracket located underneath the midd le of the front axle, continue on to step 2 . If your tractor does not have a mower deck suspension bracket underneath the midd le of the front axle
skip to step 21 on page 3 for tractors with dual suspension brackets.
REMOVAL OF PARTS FROM CARTON
Remove all parts and hardware packages from the carton. Lay out parts and hardware and identify using the illustrations on pages 4 and 6.
NOTE: Not all of the supplied parts and hardware will be needed for your particular tractor. Unneeded items may be discarded after you have completed assembly and checked operation of unit. DO NOT DISCARD the two spare shear bolts (N) and 5/16" nylock nuts (Y). Refer to the Service and Adjustments section on page 27.
CAUTION Before starting to assemble the snow thrower, remove the spark plug wire(s), set the parking brake and remove the key from the tractor ignition.
TRACTOR PREPARATION
Before performing these instructions, refer to the Service and Adjustments section of your tractor owner's manual for specifi c safety instructions.
Allow engine, muffl er and exhaust defl ector to cool before beginning.
Remove any front or rear attachment which is mounted to your tractor.
Remove the mower deck. Refer to your tractor owner's manual for removal instructions. Mark all loose parts and save for reassembly.
Remove the tractor hood. Refer to your tractor owner's manual for removal instructions.
IMPORTANT: Right hand (R.H.) and left hand (L.H.) side of the tractor are determined from the operators position while seated on the tractor.
MOWER DECK
SUSPENSION
BRACKET
FIGURE 1
INSTRUCTIONS FOR TRACTORS WITH SINGLE FRONT DECK SUSPENSION BRACKET
STEP 2: (SEE FIGURE 2)
•Remove the browning shield from the front of the tractor as shown. Hold onto the shield as you remove the second screw to prevent it from falling.
•Be sure to reinstall the browning shield when so instructed in step 3.
REMOVE
FRONT SCREWS
REMOVE
BROWNING SHIELD
FIGURE 2 | RIGHT SIDE VIEW |
7