Set Up Projector | 4. Plug in power cord into projector and wall outlet (4) and |
| depress on/off power switch. |
1.Raise the post (1) until it locks into place.
2.Raise projection mirror (2) to adjust screen elevation.
3.Remove power cord (3) from storage area.
Operating The Projector | 5. | Place LCD projection panel or film transparency in the | |
|
| center of stage glass (4). | |
Read the Important Safeguards before operating this | 6. | Set lamp brightness to “ High” or “ Low” position. See | |
| “ High/Low Lamp Control” below. | ||
projector. |
| ||
7. | Rotate focus knob (5) for sharpest image. | ||
| |||
|
!Caution
Do not illuminate lamp with projection mirror in the closed position. Heat from the lamp may produce parts that are hot to the touch and damage the optics.
1.Push power switch “ ON” to illuminate lamp.
= ON
O = OFF
2.Rotate projector (1) until projected light beam is perpendicular (90°) to the screen surface. The height at the left and right sides of the projected image should be equal.
3.Adjust angle of projection mirror (2) to raise or lower the image on the screen.
4.For best results, tilt projection screen (3) toward projector until the width of the projected image is equal at both the top and bottom.
8.If yellow/orange or blue colors appear in corners of image, rotate color tuning dial to remove colors. See Color Tuning.
Fold Down Projector
1.Depress ON/OFF power switch, then unplug power cord from outlet. Coil cord into cord storage area.
2.Close projection mirror.
3.Rotate focus knob (1) clockwise to raise projection head to maximum position.
4.Release post latch (2) and lower post until it locks in the post cradle.
5.Rotate focus knob (3) counterclockwise to lower head until it stops.
6.To move the projector, lift it from the bottom.
2 | 3M 1700 Operator’s Guide |
