3M 40800

12 2011 June

700a-NA

4-SPECIFICATIONS

IMPORTANT SAFEGUARD

5. Tape Width

36mm [1 1/2 inch] minimum to 48mm [2 inch] maximum

4. Tape

Scotch® pressure-sensitive ﬁ lm box sealing tapes.

3. Operating Conditions

Use in dry, relatively clean environments at 5o C to 50o C [40o F to 120o F] with clean, dry boxes.

Note: Machine should not be washed or subjected to conditions causing moisture condensation on

components.

• To reduce the risk associated with fire

and explosion hazards:

− Do not operate this equipment in poten-

tially ﬂ ammable or explosive environments.

WARNING

1. Power Requirements:

Electrical – 120 VAC, 60 Hz, 3.25 A

Pneumatic – 6.5 bar gauge pressure [95 PSIG], 2.5 SCFM

75 liter/minute @ 21° C., 1.01 bar maximum at maximum cycle rate.

A pressure regulator/ﬁ lter is included.

The machine is equipped with two 1/6 HP gearmotors and comes with an 2.4 m [8 foot] standard neoprene

covered power cord and a grounded plug. Contact your 3M Representative for power requirements not listed

above. Contact your 3M Representative for power requirements not listed above.

2. Operating Rate:

Belt speed is 0.5m/s [100 F.P.M.]

Actual production rate is dependent on operator's dexterity. Boxes must be 18 inches (457mm) apart minimum.

Contents

Main Instructions and Parts List 3M-Mati c 700a Adjustable Case Sealer with AccuGlide 3 Taping Heads Important Safety Information Spare Parts Page Page Page Page Page i Page Page Page Page Page Page Page Page Read, understand, and follow all safety and Allow only properly trained and quali ed Position electrical cord away from foot and Turn electrical supply off and disconnect Do not leave the machine running while Keep hands and ngers away from Keep hands clear of the upper head Keep hands, hair, loose clothing, and Always feed boxes into the machine by Do not operate this equipment Use the appropriate rigging and Use proper body mechanics when Page Page Page Page Do not operate this equipment in poten- Page Page Page Page Use the appropriate rigging and Use proper body mechanics when A B C Page Page Page Keep hands and ngers away from tape Allow only properly trained and Keep hands and ngers away from tape A B A B C Keep hands and ngers away from tape Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Figure 10440 Figure 2807 =1 16 OPTIONAL 16 35 Figure 3433 11 = Page Dessin 15234 (Page 1 of 2) Page Page Page Page Page Page Page Page Page Page Page Accuglide 3 Upper and Lower High Speed Taping Heads 2 Inch Type 10800 Instructions and Parts List Important Safety Information Spare Parts Page i Page ii Page Page Page Page Page Page Read, understand and follow all safety Allow only properly trained and quali ed Turn air and electrical supplies off on Page Page Page - Page Page -