3M MP7720 manual External Control Panel

External Control Panel

	Exit
Left/Keystone	Right/Keystone
Menu

Power

Auto	source	Lamp Status
		Indicator

•The External Control Panel is located on the top of the projector, near the rear.

•The Infrared Remote Receiver (Front and Rear) allows the projector to accept signals from the remote control. For best results, be sure to aim the control toward this sensor, without any obstructions between the two, and at a distance no greater than 6 meters/19 feet.

•The Menu button will display the menu system onscreen. Press Menu again to access the sub-menus. The Left and Right buttons help you navigate among choices and settings in the menus and sub-menus. However, when the onscreen menu is not active, the Left and Right buttons will function as Keystone +/- hot keys.

•Press the Exit button to go back to the main menu. Press Exit again to leave the menu system.

•The Status Indicator will blink or light up when the lamp needs service, cooling or replacement. See “Status Messages” on page 27. for more detailed information.

•When the projector is turned on, the back-lit Power button will blink during warm-up and lamp ignition, then stay green to indicate the projector is ready for use.

•Press the Power button for 1 second to turn the projector on or off.

•Auto key: Automatically fit in the best picture quality for current received signals.

•Source key: Select signal sources, PC/ RCA/S-video.

5

3M™ Personal Projector MP7720 © 3M IPC 2000￿