3M S10 manual Using The Magnify Feature, Freezing The Screen, Press the Magnify on button

Operating (continued)

Using The Magnify Feature

	STANBY/ON
VIDEO	RGB SEARCH
ASPECT	AUTO BLANK
MAGNIFY	VOLUME
ON
	MUTE
OFF
FREEZE	KEYSTONE
POSITION	MENU
	ENTER
ESC	RESET

1	Press the MAGNIFY (ON) button.				MAGNIFY	ON
	The projector enters MAGNIFY mode.
2	Press the POSITION button, then use the
	,	,	,	buttons to select the area
	to zoom. Press the POSITION button again
	to finalize the zoom area.
		POSITION		POSITION

3 Use the	,	buttons to adjust the zoom
level.

Press the MAGNIFY (OFF) button to exit MAGNIFY mode and restore the screen to normal.(The projector will also automatically exit MAGNIFY mode if there is a change in the input signal's state.)

NOTE • The projector will automatically exit from MAGNIFY mode if either the SEARCH, RGB, AUTO, ASPECT or VIDEO feature is used, or, if there is a change in the input signal's state.

•The correcting keystone condition may vary when the magnify function is active. In this case, please make the magnify OFF, so the correcting keystone condition will be restored.

Freezing The Screen
		FREEZE
ON	MUTE	1 Press the FREEZE button.
OFF		The [II] icon appears and the screen will freeze
FREEZE	KEYSTONE	at the current image. Press the FREEZE button
		again and the [▲] appears as the projector exits FREEZE
		mode.
POSITION	MENU
NOTE	• The freezing function will automatically finish if either the STANDBY/ON,

SEARCH, RGB, VIDEO, BLANK, AUTO, VOLUME, MUTE, POSITION or MENU button of remote control is pressed, or if a button of projector is pressed, or if there is a change in the input signal’s state.

•If the projector continues projecting the same image for a long time (i.e. you forget to exit FREEZE mode), the image might possibly remain as an afterimage. Do not leave

the projector in FREEZE mode for too long.

20