2

Switches

ON/ZERO/OFF Switch:
Press to turn the scale on. In the operation mode, press briefly to set
the display to zero. Press and hold approximately 3 seconds to turn
the scale off.
LIGHT/CAL Switch:
In the operation mode, press briefly to turn the LCD backlight on.
Press and hold approximately 3 seconds to enter the calibration mode.
g / oz Switch:
In the operation mode, press the switch located on the bottom of the
scale to change the weighing unit between “g” and “oz”.
Installing / Replacing batteries
Remove the battery covers and insert 2 AAA size batteries into each
housing, taking care with the polarities. Attach the battery covers again.
G Keep the protective cover attached when installing and/or replacing
batteries, to prevent excessive force from being added to the
weighing pan.
Weighing procedures

1. Turn on / off the scale

Press the ON/ZERO/OFF key to turn on the scale. The scale shows
all segments for a few seconds and displays zero. The backlight will turn
on for about one minute. Press and hold approximately 3 seconds to
turn the scale off.

2. Select the weighing unit

Press the g / oz switch to select a weighing unit from “g” and “oz”.

3. Weighing

Verify the reading is zero. If not, press the ON/ZERO/OFF key to
zero the display. If you use a container for weighing, place an empty
container on the weighing pan and press the ON/ZERO/OFF key to
zero the display.
Place the objects to be weighed on the pan or in the container. Wait for
the display to become stable and read the weight.
Gaeaa means overload. Remove the objects from the pan immediately.