Telephone base installation
1. Plug the small end of the larger power adapter into the power jack at the bottom of the telephone base.
DSL filter
(Optional for DSL users, see number four in the note section, below.)
2. Plug the end of the telephone line cord into the telephone jack at the bottom of the telephone base.
3. Route cords through slots.
Telephone line cord
5.Plug the other end of the telephone line cord into a telephone jack.
6. Plug the small end of | 7. Plug the large |
the smaller power adapter | end of the smaller |
into the jack on the under- | power adapter into |
side of the charger, then | an electrical outlet |
route the cord through the | not controlled by a |
slot as shown. | wall switch. |
4.Plug the large end of the larger power adapter into an electrical outlet not controlled by a wall switch.
8. You may be able to make or receive short calls. For best perform- ance, place the handset in the telephone base to charge for at least 16 hours before first use.
NOTES:
1. Use only the power adapter supplied with this product or equivalent. To order a replace-
ment power adapter, visit our website at www.telephones.att.com or call 1 (800)
2.Be sure to use an electrical outlet not controlled by a wall switch.
3.This power adapter is intended to be correctly oriented in a vertical or floor mount position.
4.If you receive high speed internet through your telephone line (commonly referred to as DSL), and you are experiencing interference during telephone conversations and/or your caller ID features are not functioning properly, install a DSL filter to the telephone line between the telephone base and the telephone wall jack. Contact your DSL service provider for a DSL filter.
