Inserting the Batteries | A4 Tech Wireless Optical Zoom Mouse

Wireless Optical Zoom Mouse

Selecting the Frequency Channel

The RF-Mouse operates on two frequency channels. To prevent interference when using two RF Mice in close proximity, a different frequency channel should be used for each mouse. Refer to the following instructions to change the frequency channel for your mouse:

1.Set the frequency channel (B) on the receiver to 1 or 2.

2.Remove the battery cover from the mouse (see the following Inserting the Batteries section).

3.Set the frequency channel (L) on the mouse to 1 or 2. (The frequency channel for mouse and receiver must be the same).

Inserting the Batteries

The RF-Mouse uses two batteries. Refer to the following to insert the batteries:

1.Press the tab on the bottom of the mouse cover as shown here and remove the cover.

2.Insert the two batteries. (The correct polarity is indicated on the battery compartment casing.)

3.Replace the cover.

B

L

-3-

PDF 檔案以 "FinePrint pdfFactory Pro" 試用版建立 http://www.pdffactory.com

Image 4

A4 Tech Wireless Optical Zoom Mouse manual Selecting the Frequency Channel, Inserting the Batteries

Contents

Wireless Optical Zoom Mouse User’s Guide Wireless Optical Zoom Mouse Connecting the RF-Mouse Receiver Locating the RF-Mouse Receiver Selecting the Frequency Channel Inserting the Batteries Receiver works as a charger About the indicating light LED on receiver Checking the Batteries power Installing the iZoomWorks SoftwarePower On/Off switch RF-Mouse ID code Connecting the RF-Mouse ID CodeChanging the RF-Mouse ID Code Why use iZoomWorks Using Pan and Zoom in/out Setting the Zoom Speed 3rd wheel button Net/LuckyJump Commands Wireless Optical Zoom Mouse