AAMP of America PXDP2

To program the interface, set the dip-switches located on the side of the

interface (see Fig.1 below) to the conguration listed for your radio on the

Harness and Dip Switch Conguration Chart. Switches are in their default

setting of “off” in the up position and are turned “on” when switched down.

Refer to the chart on the bottom of this page.

This programs the iPod2car to the radio it is being connected to. The dip-

switches MUST be set before the interface is plugged into the vehicle.

otherwise the iPod2car will not work correctly.

Brand Mode Harness 1 2 3 4 5 6 7 8

FORD SAT PXH2FD1 ON ON ON oFF oFF oFF oFF oFF

Fig.1 Side view of Interface with dip switches

OFF

↓

In this section you will be instructed on how to connect the iPod2car Gen2

oEM to your factory radio.

1. Carefully remove the trim panels covering the 7mm bolts that secure the

radio into the dash cavity. remove these bolts, and remove the radio from

the dash of the vehicle.

2. Plug in the PXH2FD1 harness into the 24-pin port and 16-pin

port on the back of the radio. next connect the factory 24-pin and 16-pin,

if present, into the female connectors on the harness. Be sure to make a

rm connection but do not force it.