TOP VIEW
1 2 345678
DIP ON
DIN CONNECTOR / DIP SWITCH VIEW
22-PIN HARNESS VIEW
Now that you have identied the correct harness and dip-switch conguration us-
ing the application guide, it is now time to program the interface.
To program the interface, set the dip-switches located on the side of the interface
(see Fig.1 below) to the congguration listed for your vehicle in the Application
guide. Switches are in their default setting of “off” in the up position and are turned
“on” when switched down. Refer to the chart on the bottom of this page.
This programs the Audio2car to the vehicle it is being installed in. The dip-switches
MUST be set before the interface is plugged into the vehicle. Otherwise the
Audio2car will not work correctly.
Dip Switch Conguration Chart
Fig.1 Side view of Interface with dip switches
1 2 3 4 5 6 7 8
Cong. #1 ON off off ON off off off off
Cong. #2 ON off off off off off off off
Cong. #3 off off off ON off off off off
Cong. #4 off ON off off off off off off
Cong. #5 ON ON off off off off off off
Cong. #6 off off ON off off off off off
Cong. #7 ON off ON off off off off off
Cong. #8 off ON ON off off off off off
Cong. #9 ON ON off ON off off off off