SERVICE & MAINTENANCE

ANNUAL MAINTENANCE

It is important that your fire is regularly serviced in accordance with these instructions. This should be carried out at least annually by a qualified person

and should consist of the following.

Remove the fire lining(s), and throat plate, inspect all gasketing on doors, glass etc. and re-order any items that may need replacing, from your Aarrow dealer. With a wire brush clean inside the appliance paying particular attention to the small inlet holes of the air wash on the inside of the stove, above the fire door. Ensure the inside face of the fire door is free of debris around the area of the primary air inlet.

Sweep the chimney and confirm that it is sound. Examine all joints in the flue pipe etc. and re-seal if necessary.

SUMMER STORAGE/NON USAGE

Please ensure that your stove is left clean and moving components are well lubricated for the summer months (during periods of prolonged non use). If possible store the throat plate outside of the stove, check all movable components, at regular intervals, to ensure they are moving freely.

Allow air movement through the stove, by opening the airwash and prinmary air inlet(s) controls to about half way open or leave the door ajar. This will allow a free flow of air through the appliance thus preventing moisture and condensation forming inside the stove and chimney. This preventative maintenance will ensure your stove stays in the best condition for the coming winter months.

DOOR ADJUSTMENT

Once the appliance has been under fire for a period of time the fire door may appear to have moved out of alignment with relation to the door aperture.

This is quite normal and due to the settling of the casing.

The fire door can be re-aligned by the user as follows:

•When the appliance is cold, open the fire door so that it is at a right angle to the front face of the fire.

•Lift the fire door up off the hinges. .

•Gently tap the two hinge pins in a direction to compensate for the misalignment.(Fig.13)

•Refit the door and check to ensure it now sits square to the body; if not repeat above steps.

Raising the door as follows:

•When the appliance is cold, open the fire door so that it is at a right angle to the front.

•Lift the fire door up off the hinges.

•Drop one washer on the top and bottom hinge pin

.

•Refit the door and check.

Please Note: There is no adjustment to the door lock/catch assembly.

Fig. 13. Adjusting the door hinge

Aarrow Ecoburn Wood & Multifuel Stoves

21