Service
Perform only the routine maintenance procedures referred to in these instructions.
Do not attempt to service or repair the laminator.
Unplug the unit and contact an authorized GBC service representative for any required repairs or one or more of the following has occurred:
•The power supply cord or attachment plug is damaged.
•Liquid has been spilled into the laminator.
•The laminator is malfunctioning after being mishandled.
•The laminator does not operate as described in these instructions.
WARNING: THIS IS NOT A TOY - DO NOT ALLOW CHILDREN TO OPERATE THIS LAMINATOR!
Installation
•Shipping damage should be brought to the immediate attention of the delivering carrier.
•Place the laminator on a stable flat surface capable of supporting 44lbs. The surface should be at least 30” high to assure comfortable positioning during operation. All four rubber feet should be on the supporting surface.
•Connect power cord to an appropriate power source. Avoid connecting other equipment to the same branch circuit to which the laminator is connected as this may cause nuisance tripping of the circuit breaker or blown fuses.
Caring for the Ultima 35 EZload
The only maintenance required by the operator is to periodically clean the heat shoes. The following procedure will help keep the heat shoes free of adhesive that has been deposited along the edge of the laminating film.
CAUTION: THE FOLLOWING PROCEDURE IS PERFORMED WHILE THE LAMINATOR IS HOT. USE EXTREME CAUTION.
WARNING: Do not apply cleaning fluids or solvents to the rollers.
WARNING: Do not attempt to laminate adhesives marked ‘Flammable’.
•The laminator should be positioned to allow exiting film to drop freely to the floor. Accumulation of laminate as it exits the laminator may cause film to wrap around the rollers, causing a jammed condition.
•Avoid placing laminator near sources of heat or cold. Avoid locating the laminator in the direct path of forced, heated or cooled air.
1Remove the film from the laminator following the procedure outlined in the section FILM LOADING AND THREADING.
2Preheat the laminator until the READY LAMP ( 
) illuminates.
3Clean the top and bottom heat shoes with a soft cloth.
4Follow the procedure in section FILM LOADING AND THREADING, Method Using Film Threading Card to reload the laminator.
NOTE: Do not use metal scouring pads to clean the heat shoes!
WARNING: Do not laminate glitter and/or metallic items. Damage to the rollers may result.
ABC Office | 800.658.8788 | www.abcoffice.com 5 |
