Film Loading and Threading
Refer to Figure 6 and follow the procedures to remove the Feed Table and Heat Shield.
1Remove the heat shield by sliding it to the left or right and lifting it up and away from the laminator.
2Slide the feed table latch to the left.
3Lift the feed table upwards and away from the laminator.
CAUTION: HEAT SHOES COULD BURN YOU.
If reloading film, cut the remaining top and bottom film webs between the supply rolls and heat shoes. Be careful not to scratch the heat shoes. Remove the old rolls and check the heat shoes for adhesive residue. This can be easily removed by wiping with a damp cloth. Do not use abrasive, as they will damage the Teflon coating on the heat shoe.
Change the top and bottom supply roll at the same time.
4Raise the four film holder levers and remove old rolls of film (figure 7).
5Install new film rolls making sure that color and diameter of end plugs correspond to the size of the holder and colour sticker located on the side plate of the laminator.
6Close the four film holder levers.
7Refer to Figure 8 or Threading Guide located on the feed table for illustration of properly loaded film. Unwind top and bottom film rolls allowing enough slack for threading. Drape the film from lower supply roll over the heat shoes allowing enough slack to
8
9
10Move the RUN / STOP / REVERSE SWITCH ( 
) to the ‘RUN’ ( 
) position. Slide the threading card (provided with new rolls of GBC laminating film) on the feed table, gently pushing the film into the nip rollers (figure 10). The threading card should now be guiding both rolls of film through the laminator.
11Move the RUN / STOP / REVERSE SWITCH ( 
) to the ‘STOP’ ( 
) position when the threading card exits the rear of the laminator.
CAUTION: | SHARP BLADE. |
12The film cutter may be used to separate the laminated items. Position the cutter on either side of the laminator, depress the cutter handle while sliding the cutter across the film.
A |
B |
C |
D |
E |
ABC Office | 800.658.8788 | www.abcoffice.com 7 |
