Watson-Marlow 620DuN and 620Du User Manual 9
Outputs
A 0-10V, 4-20mA or 0-1478Hz output signal provides feedback of the pump
speed. There are four relay status outputs which can be configured in software
for a variety of pump parameters.
MemoDose
Allows repeat dosing. Stores in memory a pulse count from the motor. This
count is repeated each time START is pressed to provide a single-shot dose.
Calibration
Full calibration with default figures for a range of pumpheads and tubes.
Calibration dose facility.
Serial communications
Full pump control from a PC or other controller with the ability to network up to
16 pumps (620Du) or 32 pumps (620DuN).
Guard switch
Primary operator protection from rotating parts of the pump is provided by the
fixed guard. Secondary operator protection from rotating parts of the pump is
provided by indicator-only switching of the pumphead guard.
PIN-secure process protection
Two levels of control protection: main PIN code and user PIN code.
IP NEMA
1st Digit 2nd Digit
3
Protected against
ingress of solid objects
with a diameter of
more than 2.5mm.
Tools, wires etc with a
thickness of more than
2.5mm are prevented
from approach
1
Protection against
dripping water falling
vertically. No harmful
effect must be
produced
2
Indoor use to provide a
degree of protection
against limited
amounts of falling
water and dirt
5
Protected against
harmful dust deposits.
Ingress of dust is not
totally prevented but
the dust must not
enter in sufficient
quantity to interfere
with satisfactory
operation of the
equipment. Complete
protection against
contact
5
Protection against
water projected from a
nozzle against the
equipment (enclosure)
from any direction.
There must be no
harmful effect (water
jet)
12
Indoor use to provide a
degree of protection
against dust, falling
dirt and dripping, non-
corrosive liquids
13
Indoor use to provide a
degree of protection
against dust and
spraying of water, oil
and non-corrosive
coolants
6
Protection against
ingress of dust (dust-
tight). Complete
protection against
contact
6
Protection against
heavy seas or powerful
water jets. Water must
not enter the
equipment (enclosure)
in harmful quantities
(splashing over)
4X
Indoor or outdoor use*
to provide a degree of
protection against
splashing water, wind-
blown dust and rain,
hose-directed water;
undamaged by the
formation of ice on the
enclosure. (Resist
corrosion: 200-hour
salt spray)
IP (Ingress Protection) and NEMA definitions
* 620 cased pumps are rated to NEMA 4X (indoor use) only.