INSTALLATION
13
14
15
Attach the microswitch cable assembly to the microswitch's in- stalled in step 12. See diagram for proper connection.
Find a suitable location for the main Tempest electrical box on the NOPS of the press. Route the exhaust fan cable (this cable has female pins in the connector on the end) into the delivery and connect it to the exhaust fan installed in a previous step. Route the impression signal cable (this cable has male pins in the connector on the end) through the press and connect it to the the cable that was attached to the
Remove the cover from the main Tempest® electrical cabinet and insert the dryer cable through the strain relief on the bottom of the box. Insert the wires into the green connector by matching the number on the wire to the number on the connector. Secure the ground wire to the stud on the inside of the box. Tighten the strain relief and replace the cover on the box.
17
