Access PCI-DIO-24D(H) Chapter 7: 8254 Counter/Timer

Chapter 7: 8254 Counter/Timer

These cards have the option of one, two, or three 82C54 counter(s) that each include three 16-bit

counter/timers factory configured in an optimal module for use as event counters, frequency output, pulse

width, and frequency measurement (See Block Diagram). Each counter can be programmed to any count

as low as 1 or 2, and up to 65,535, depending on the mode chosen. For those interested in more detailed

information, a full description can be found in the Intel (or equivalent manufacturer's) data sheet.

The 8254 modes of operation are described in the following paragraphs to familiarize you with the

versatility and power of this device. For those interested in more detailed information, a full description of

the 8254 programmable interval timer can be found in the Intel (or equivalent manufacturers') data

sheets. The following conventions apply for use in describing operation of the 8254 :

Clock: A positive pulse into the counter's clock input

Trigger: A rising edge input to the counter's gate input

Counter Loading: Programming a binary count into the counter

Mode 0: Pulse on Terminal Count

After the counter is loaded, the output is set low and will remain low until the counter decrements to zero.

The output then goes high and remains high until a new count is loaded into the counter. A trigger

enables the counter to start decrementing.

Mode 1: Retriggerable One-Shot

The output goes low on the clock pulse following a trigger to begin the one-shot pulse and goes high

when the counter reaches zero. Additional triggers result in reloading the count and starting the cycle

over. If a trigger occurs before the counter decrements to zero, a new count is loaded. This forms a

retriggerable one-shot. In mode 1, a low output pulse is provided with a period equal to the counter count-

down time.

Mode 2: Rate Generator

This mode provides a divide-by-N capability where N is the count loaded into the counter. When

triggered, the counter output goes low for one clock period after N counts, reloads the initial count, and

the cycle starts over. This mode is periodic, the same sequence is repeated indefinitely until the gate

input is brought low. This mode also works well as an alternative to mode 0 for event counting.

Mode 3: Square Wave Generator

This mode operates like mode 2. The output is high for half of the count and low for the other half. If the

count is even, then the output is a symmetrical square wave. If the count is odd, then the output is high

for (N+1)/2 counts and low for (N-1)/2 counts. Periodic triggering or frequency synthesis are two possible

applications for this mode. Note that in this mode, to achieve the square wave, the counter decrements by

two for the total loaded count, then reloads and decrements by two for the second part of the wave form.

Mode 4: Software Triggered Strobe

This mode sets the output high and, when the count is loaded, the counter begins to count down. When

the counter reaches zero, the output will go low for one input period. The counter must be reloaded to

repeat the cycle. A low gate input will inhibit the counter.

Mode 5: Hardware Triggered Strobe

In this mode, the counter will start counting after the rising edge of the trigger input and will go low for one

clock period when the terminal count is reached. The counter is retriggerable. The output will not go low

until the full count after the rising edge of the trigger.

Manual PCI-DIO-24DH