Operation, hot lamination
1Connect the power cord plug to the appropriate power source.
2Push the power button to “ON” position, the LCD display will illuminate.
3Using the lamination guide located on the machine (fig.1), select the appropriate temperature setting for the pouch gauge thickness and material you are laminating using the Up/Down Arrow keys.
Temperature Setting Guidelines
When laminating thin paper with light ink coverage, set the temperature dial to the low end of the film gauge range. Thick paper with heavy ink coverage requires higher settings within the range. Temperature settings will vary due to the finish, chemistry and heat absorption properties
of the material being laminated. If the laminated pouch is cloudy after the first pass through the machine, adjust the temperature to the next higher position and run it through again. If waviness occurs, reduce the temperature to the next lower position. Always allow sufficient time for the laminator temperature to adjust to the changes made to the settings.
4When the laminator has reached the correct lamination temperature the countdown to ready will indicate “Ready” 0 minutes on the LCD display.
5Centre the item to be laminated within the pouch left to right with the top edge against the sealed edge of the pouch (fig.2).
6Insert the pouch with the sealed edge first into the machine (fig.3).
7The laminated item will automatically exit at the rear of the machine. After the pouch has stopped moving, carefully remove from the machine and place on a cool flat surface for approximately one minute for cooling (fig.4).
8If you are finished laminating push the power switch to turn the machine off.
Guarantee
Operation of this machine is guaranteed for two years from date of purchase, subject to normal use. Within the guarantee period, ACCO Brands Europe will at its own discretion either repair or replace the defective machine free of charge. Defects due to misuse or use for inappropriate purposes are not covered under the guarantee. Proof of date of purchase will be required. Repairs or alterations made by
Register this product online at www.accoeurope.com
G
Operation, cold lamination
1Connect the power cord plug to the appropriate power source.
2Push the power button to “ON” position. The LCD display will illuminate (fig.1).
3The LCD display will automatically default to the “0” * Temp. position.
4Follow the instructions included with your GBC self adhesive laminate or other pressure sensitive, non thermal laminating pouches.
Reverse feature
In the event of a misfeed or a jam follow these instructions.
1 Press the reverse button and hold down (fig.5). This will reverse the rotation of the rollers allowing the pouch to exit the front of the machine.
2Pull the document out of the laminator.
3After the document is out of the machine clean the rollers by running the cleaning sheet through the laminator.
mCaution: Use caution when removing the laminated pouch from the machine. It may be hot.
persons not authorised by ACCO Brands Europe will invalidate the guarantee. It is our aim to ensure that our products perform to the specifications stated. This guarantee does not affect the legal rights which consumers have under applicable national legislation governing the sale of goods.
