YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS IMPORTANT TO GBC. IN THIS INSTRUCTION MANUAL AND ON THE PRODUCT ARE IMPORTANT SAFETY MESSAGES. READ THESE MESSAGES CAREFULLY.
THE SAFETY ALERT SYMBOL PRECEDES EACH SAFETY MESSAGE IN THIS INSTRUCTION MANUAL.
THIS SYMBOL INDICATES A POTENTIAL PERSONAL SAFETY HAZARD THAT COULD HURT YOU OR OTHERS, AS WELL AS CAUSE PRODUCT DAMAGE OR PROPERTY DAMAGE.
THE FOLLOWING WARNING IS FOUND ON THE BOTTOM OF THE PRODUCT.
WARNING
Electrical shock hazard. Do not open. No user servicable parts inside. Refer servicing to qualified
WARNING: FOR YOUR PROTECTION DO NOT CONNECT THE POUCH LAMINATOR TO ELECTRICAL POWER UNTIL YOU READ THESE INSTRUCTIONS COMPLETELY. KEEP THESE INSTRUCTIONS IN A CONVENIENT LOCATION FOR FUTURE REFERENCE. TO GUARD AGAINST INJURY, THE FOLLOWING BASIC SAFETY PRECAUTIONS MUST BE OBSERVED IN THE SET-UP AND USE OF THIS PRODUCT.
General safeguards
• Use the unit only for its intended purposes of laminating documents. |
• Do not place anything in the throat opening of the laminator other |
than pouches/documents. |
• Place unit on a secure, stable work area to prevent the unit from |
falling and possibly causing personal injury and damage to the unit. |
• Follow all warnings and instructions marked on the unit. |
Connect power cord to appropriate power source.
GBC Heatseal H65/H75 Laminator is designed for 2 x 75 micron (total 150) up to 2 x 125 micron (total 250) pouches.
1Choose the right setting (fig. 1).
The laminator has 2 temperature settings positioned on the front:
‘Std. Paper’– when laminating with Standard paper (less than 200 g per sq. metre)
‘Photo paper’– when laminating with Photo paper (more than 200 g per sq. metre)
2Push the switch located on the right side to “On” (I) (fig. 2a). The red “Power” indicator lamp will illuminate (fig. 2b).
3The “Ready” indicator lamp will glow green when the laminator reaches lamination temperature (fig. 3).
Note: It is normal for the Ready Light to cycle On and OFF after initial warm up. You can continue laminating.
4Position the paper to be laminated into a GBC laminating pouch, so that the document is aligned to the folded edge and right and left borders are equal (fig. 4).
5Insert the pouch and its content straight into the machine, leading with the folded edge (fig. 5).
6The laminated item will automatically exit at the rear of the pouch laminator (fig. 6). Immediately after the pouch has stopped moving, place it on a flat surface to cool for one minute before handling.
7If you have finished laminating, then move the switch to the "off"
(0)position (fig. 7).
Do not laminate an empty pouch.
To correct misfeeds, press and hold the release button (fig. 8), located at the back of the machine, while pulling the misfed material out of the laminator.
Special notice
Thank you, for your recent purchase of a GBC Pouch Laminator. Your new laminator may emit a slight odour during the initial stage of operation. It is normal and will diminish after several hours of operation.
• Do not overload electrical outlets beyond their capacity; fire or |
electrical shock could result. |
• The unit is intended for indoor use only. |
• Never push objects through the cabinet slots. Do not spill liquid of |
any kind on this product. |
• Close supervision is required when this product is used near |
children. |
1As soon as the lamination is completed, remove from the rear of the machine and place on a cool flat surface for cooling to prevent the pouch from curling.
2If the laminated item appears to be cloudy, it means that the laminator temperature is not hot enough. Allow the laminator to heat for a few more minutes then run the pouch through again. If the laminated item is wavy, the laminator is too hot. Verify temperature selector is set at the appropriate temperature.
3Do not attempt to do single sided lamination. This will destroy the laminator.
4Do not block the vent slots, this will cause the laminator to overheat.
5Before laminating important or unique documents always run a test pouch through the laminator using a similar type document.
Guarantee
Operation of this machine is guaranteed for two years from date of purchase, subject to normal use. Within the guarantee period, GBC will at its own discretion either repair or replace the defective machine free of charge. Defects due to misuse or use for inappropriate purposes are not covered under the guarantee. Proof of date of purchase will be required. Repairs or alterations made by persons not authorised by GBC will invalidate the guarantee. It is our aim to ensure that our products perform to the specifications stated. This guarantee does not affect the legal rights which consumers have under applicable national legislation governing the sale of goods.
4
Service
•Do not attempt to service or repair the pouch laminator yourself. Unplug the unit and contact an authorized GBC service representative for any required repairs.
Cleaning
Caution: Unplug this product before cleaning.
•Wipe exterior only with a damp cloth. Do not use detergents or solvents.
Specifications
| GBC HeatSeal H65 | GBC HeatSeal H75 |
| | |
Electrical | 230v / 50 Hz / 0.65 Amps / 150 W | 230v / 50 Hz / 0.87Amps / 200 W |
| | |
Machine Dimensions | 362 x 108 x 102mm | 451 x 108 x 102mm |
| | |
Machine Weight | 2.5 kg | 3.0 kg |
| | |
Maximum Pouch Width | 241mm | 318mm |
| | |
Maximum Pouch Thickness | 2 x 125 mic (Total 250) | 2 x 125 mic (Total 250) |
| | |
Maximum Thru-put Thickness | 0.8mm | 0.8mm |
| | |
Warm-Up Time (2 x 75 mic.) | 8 minutes | 8 minutes |
| | |
Register this product online at www.gbceurope.com
5
