User Guide
6
Troubleshooting
If you experience any problems with the module, check the following items before
contacting Accton Technical Support:
• Ensure the switch with the fiber optic module is powered up.
• Ensure that the device attached to the module is powered up and operating correctly.
• Ensure that the module is properly seated in the slot.
• Verify that the module port is configured to match the communication mode used
by the attached device (full or half duplex).
• Check the connectors on both ends of the cable to be sure they are properly
engaged. When attaching fiber cable to an SC-type port, be sure the plug clicks
into place to ensure that it is properly seated.
• If you are using fiber optic cable with an ST-type connector (in conjunction with the
SC-ST converter*), try switching the TX and RX connectors.
• Be sure the fiber terminators are clean. You can clean the cable plugs by wiping
them gently with a clean tissue or cotton ball moistened with a little ethanol. Dirty
fiber terminators on fiber optic cables will impair the quality of the light transmitted
through the cable.
* You may use the Cheetah ST Converter (Part Num ber: ST5002) to attach 62.5/
125 micron fiber cable with an ST-type connector to the SC-type port on the fiber
optic module.
Product Specifications
Access Method CSMA/CD
Ports 1 10000BASE-LX
Network Interface SC connector:
62.5/125 or 50/125 micron multimode fiber cable
9/125 micron single-mode fiber cable
Communication Mode Full or half duplex,
auto-negotiation for duplex mode and flow control
Size 12.25 x 90.70.5 x 2.74 cm (4.82 x 3.57 x 1.08 in.)
Power Consumption 2.4 W maximum
Temperature Operating: 0 to 50°C (32 to 122°F)
Storage: -40 to 158°C (-40 to 70°F)
Humidity 5% to 95%
Standards IEEE 802.3z Gigabit Ethernet
ISO/IEC 8802-3
Compliances CE Mark
Emissions FCC Class A
VCCI Class A
Industry Canada Class A
EN55022 (CISPR 22) Class A
C-Tick - AS/NZS 3548 (1995) Class A
Immunity IEC 1000-4-2/3/4/6
Warranty Three years