Step 2 - Verify Gas Level
Before starting this generator, verify that there is sufficient gasoline in the fuel tank. The fuel gauge, located on the top of this generator, indicates the gas level currently in the fuel tank. If necessary, add fresh unleaded gasoline with an octane rating of 87 or higher according to “Step 2 - Add Gasoline” of the “Using this Generator for the First Time” section of this manual.
Model | 6.5 / 24.6 |
Model | Fresh, Unleaded Gasoline Octane Rating 87 or Higher |
Gasoline and gasoline fumes are highly flammable and explosive. Handling fuel can result in serious injury or burns.
•Do not fill the fuel tank near a heat, sparks or an open flame. Keep gasoline away from appliance pilot lights, barbecues, electric appliances, power tools, etc.
•Always allow several minutes for the engine to cool before refueling.
•Do not overfill the fuel tank. Always check for fuel spills and immediately wipe them up. Spilled fuel is a fire hazard and causes environmental damage.
IMPORTANT:
•Use only fresh UNLEADED gasoline with an octane rating of 87 or higher.
•Never use old and/or contaminated gasoline.
•Never use a mixture of oil and gasoline.
•Avoid getting dirt and/or water in the fuel tank.
•Never store generator for extended time with gasoline in the fuel tank.
Step 3 - Ground the Generator
Failure to properly ground this generator can result in electrocution.
Ground this generator by tightening the grounding nut against a grounding wire as previously illustrated in Figure 3. A generally acceptable grounding wire is a No. 12 AWG (American Wire Gauge) stranded copper wire. The other end of this grounding wire should be connected to a copper or brass grounding rod that is driven into the earth.
Grounding codes can vary by location. Contact a local electrician for information on grounding regulations for your area.
STARTING THE GENERATOR
STOP!
Before starting this generator, confirm that all the steps in the section titled, “Preparing the Generator for Use,” of this manual have been correctly completed. If unsure about how to perform any of these steps, call
Disconnect all electrical loads from this generator before attempting to start.
A 12 Volt motorcycle battery no larger than 7 1/8" length, 6 1/4" height, and 3 9/16" width is required for electric start of this generator. The location for the battery is behind the metal plate under the electrical panel. If the electric start feature of this generator will be used, first install the battery using the two included cables (one red and the other black) according to the following procedure:
1.Attach one end of the red cable to the positive terminal on the battery and the other end of the red cable to the celenoid.
2.Attach one end of the black cable to the negative terminal on the battery and the other end of the black cable to the bolt on the mounting bracket frame.
Model | 14 |
