Installing the Mylex Disk Array Controller as the Primary Windows NT 4.0 Controller

9.Select the appropriate controller from the list of controllers displayed on this screen and press <Enter>.

10.If you have drivers to install for other controllers (for example, an on-board SCSI or IDE controller to run other devices such as a CD- ROM drive, etc.), repeat Step 6 and Step 7. Then when prompted, insert the manufacturer’s supplied hardware support disk, press <Enter>, and select the appropriate driver from the list.

If you have no other drivers to install, or when you have finished installing other drivers, simply press <Enter> to continue installation.

11.Insert Windows NT 4.0 setup diskette #3 when prompted.

12.Follow the on-screen instructions to continue Windows NT 4.0 installation, inserting the Windows NT CD-ROM into the CD-ROM drive when prompted. Press <Enter> and continue with the next few Windows NT 4.0 installation screens.

13.When prompted again for the “MDAC Software Kit” diskette, insert the NT4/NW Drivers Software Kit diskette into the floppy disk drive and press <Enter>.

If you installed other drivers from other diskettes, you will be asked to reinsert those diskettes as well.

This concludes Mylex Disk Array Controller driver installation for Windows NT 4.0. Follow the on-screen instructions to complete your installation of the Windows NT 4.0 operating system.

3-4

PCI Disk Array Controller Drivers Manual