Installing the Mylex Disk Array Controller as the Primary UnixWare Controller with UnixWare 7.x/2.1.3

☛Note

If installing onto a system that is SISL capable and using a SISL capable DAC it is recommended to disable the SCSI chip driver on the system by entering the DCU at the appropriate screen then select Software Device Drivers and disable the appropriate driver.

3.Boot the system from the UnixWare Diskette.

4.Follow the instructions provided in the UnixWare Installation Handbook. The Mylex Disk Array Controller driver for UnixWare is included on the Software Kit UnixWare (dak) driver diskette which was made from the Software Kit CD-ROM.

•During the installation, you will be prompted to either Install Host Bus Adapter Drivers or Continue Installation.

•Select Install Host Bus Adapter Drivers,

•Insert the Software Kit UnixWare (dak) driver diskette as instructed, and continue with the instructions provided in the UnixWare Installation Handbook.

•The controller should be detected automatically during the install process.

5.After the installation of boot files, the system is automatically shut down.

Use /dev/rct0 and /dev/cdrom/c0b0txl0 (x is the CD-ROM SCSI ID number) to access tape and CD-ROM devices after installation.

U

N

6 I

X

W

A

R

E

6-4

Manual No. 775079