Acer 2000 manual Advanced, FIR Ports, Description Option, IRQ4/ COM4, 2E8, IRQ3

Advanced

The Advanced screen contains parameters involving your hardware devices. It also provides advanced settings of the system.

FIR Ports

Configure the system’s infrared port using options: Disabled and Enabled.

Insyde Software SCU

Main Advanced

\ FIR Ports

		May 20, 2003 5:40:09
	Security	Boot	Exit
---------------------------------		--------------------------------FIR Ports

LPT Port

Legacy USB

-----FIR I/O settings---
(	) Disabled
(	) COM1,3F8,IRQ4
(	) COM2,2F8,IRQ3
(	) COM3,3E8,IRQ4
(	) COM4,2E8,IRQ3
	OK

-Mode Setting for IRDA-

( ) Normal (16550)

( ) IrDA (HPSIR)

() ASK IR

( ) FAST IR

--DMA Setting For Fast IR-- ( ) DMA1

( ) DMA2

( ) DMA3

Cancel

<Tab> <Right> <Left> for block select. <Up> <Down> for item select.

<Enter> for accept. <Cancel> <Esc> for reject. <Alt> activates accelerators. <Space> for Enable or Disable.

The table below describes the parameters in the screen. Settings in boldface are the default and suggested parameter settings.

	Description	Option
FIR I/O Settings	Sets the base I/O address and IRQ for	COM1, 3F8, IRQ4/ COM2,
	Infrared port.	2F8, IRQ3/ COM3, 3E8,
		IRQ4/ COM4, 2E8, IRQ3
DMA Setting for Fast	Sets a DMA channel for the printer to	DMA1, DMA2, DMA3,
IR	operate in ECP mode. This parameter is
	enabled only if Mode is set to ECP.
Mode Setting		Normak (16550), IrDA
		(HPSIR), ASK IR, FAST IR

Chapter 2 41