48

3 Troubleshooting my computer

connectors and there is only one PS/2 port on the computer.

To connect two PS/2-type devices to the computer, you need to use an optional PS/2 Y-bridge connector.

The printer does not work.

Check the following:

Make sure that the printer is connected to a power outlet and that it is turned on.

Depending on your connection (USB or parallel), make sure that the printer cable is connected securely to the appropriate port on your computer and the corresponding port on the printer.

During POST, press F2 to access the BIOS Utility and verify that the parallel port is enabled if you use a parallel printer.

I want to set up my location to use the internal modem.

To properly use your communications software, you need to set up your location:

1Click on Start, Control Panel.

2Double-click on Phone and Modem Options.

3Click on the Dialing Rules tab and begin setting up your location. Refer to Windows Help and Support.

Page 58
Image 58
Acer 260 series manual Connectors and there is only one PS/2 port on the computer, Printer does not work