49

4In the Acer eRecovery window, select Recovery settings and click Next.

5In the Recovery settings window, select Burn image to disk and click Next.

6In the Burn image to disk window, select 01. Factory default image and click Next.

7Follow the instructions on screen to complete the process.

Re-install bundled software without CD

Acer eRecovery stores pre-loaded software internally for easy driver and application re-installation.

1Boot to Windows XP.

2Press <Alt> + <F10> to open the Acer eRecovery utility.

3Enter the password to proceed. The default password is six zeros.

4In the Acer eRecovery window, select Recovery actions and click Next.

5In the Recovery settings window, select Reinstall applications/drivers and click Next.

6Select the desired driver/application and follow the instructions on screen to re-install.

At first launch, Acer eRecovery prepares all the needed software and may take few seconds to bring up the software content window.

Change password

Acer eRecovery and Acer disk-to-disk recovery are protected by a password that can be changed by the user. Follow the steps below to change the password in Acer eRecovery.

1Boot to Windows XP.

2Press <Alt> + <F10> to open the Acer eRecovery utility.

3Enter the password to proceed. The default password is six zeros.

4In the Acer eRecovery window, select Recovery settings and click Next.

5In the Recovery settings window, select Password: Change Acer eRecovery password and click Next.

6Follow the instructions on screen to complete the process.

Note: If the system crashes, and will not boot to Windows, you can run Acer disk-to-disk recovery to restore the factory default image under DOS mode.

English

Page 59
Image 59
Acer 3610 Series manual Re-install bundled software without CD, Change password