Parameter | Description | Submenu Items |
|
|
|
On chip SATA | Enable On chip SATA. | Option: Enabled or Disabled |
SATA Class ID | Select the SATA Class ID. | Option: |
|
| HyperFlash Class, |
|
| Class, IDE Native Mode, Raid Class, |
|
| ACHI Class, or IDE Legacy Mode |
|
|
|
SATA IDE | Set SATA IDE Combined mode. | Option: Disabled or Enabled |
Combined mode |
|
|
|
|
|
PATA Channel | Set the SATA channel as Primary or | Option: SATA as primary or SATA |
Config | Secondary channel. | as secondary |
|
|
|
ACHI ROM | Select SATA option ROM POST delay. | Option: Disabled, 7, 6, 5, 4, 3, 2, or |
POST delay |
| 1 second(s) delay |
USB Host | Enable or disable USB hardware. | Option: Enabled or Disabled |
Controller |
|
|
|
|
|
Legacy USB | Enable support for Legacy Universal Serial | Option: Enabled or Disabled |
Support | Bus. |
|
|
|
|
Option ROM | Determines which peripheral devices can | Option: Disabled, Temporary, or |
Placement | be booted. | E000 Extend |
| NOTE: Changes to this setting can cause |
|
| the system to halt during boot. |
|
Large Disk | Set the Large Disk Access mode. Different | Option: DOS or Other |
Access Mode | O/S require different drive geometry |
|
| representations. Select Other for UNIX, |
|
| Novell NetWare, or other O/S. |
|
Installed O/S | Set the most commonly used O/S on the | Option: Other, Win2000, WinMe, |
| system. | Win98, or Win95 |
|
|
|
Reset | Clear Extended System Configuration Data | Option: No or Yes |
Configuration | (ESCD) area. |
|
Data |
|
|
|
|
|
Processor | Enable the hardware visualization support. | Option: Enabled or Disabled. |
Assisted |
|
|
Virtualization |
|
|
|
|
|
Chapter 2 | 31 |
