Acer AC 711 Federal Communications Commission, Connecting the Monitor and Swivel Base

Federal Communications Commission

( FCC Statement )

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. T hese limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

nReorientate or relocate the receiving antenna;

nIncrease the separation between the equipment and receiver;

nConnect the equipment with a power socket on a circuit different from that to which the receiver is connected;

nConsult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the manufacturers may void t he user’s authority to operate this equipment.

A shielded-type video signal cable is required in order to meet the FCC emission limits and also to prevent interference to nearby radio and television reception. It is essential t hat only the supplied power cord be used.

Use only shielded cables to connect I/O devices to this equipment.

Canadian DOC Notice

For Class B Computing Devices

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

Connecting the Monitor and Swivel Base

1. Place the monitor with its tube down on a stable surface.

2. Align the four tabs of the swivel base with the slots in the bottom of the monitor.

3. Insert the tabs into the slots of the monitor

4. Now slowly slide the swivel base toward the front of the monitor till you hear the spring lock click into place.

Removing the Monitor and Swivel Base

If you need to remove the swivel base, push the spring lock and then pull the swivel base away from the monitor.

NOTE:Special attention should be paid to the control knobs and LED indicators on the front panel when you place the monitor with its tube down. This will prevent damage to these control knobs and LED indicators from excessive pressure.

2