23
Security | Security |
|
| This projector provides a useful security function for the | |
| administrator to manage usage of the projector . | |
| Press | to change the "Security" setting. If the security function |
| is enabled, your must enter the "Administrator Password" first | |
| before changing the security settings. | |
•Select "On" to enable the security function. The user has to enter a password to operate the projector. Please refer to the "User Password" section for details.
•If "Off" is selected, then the user can turn on the projector without password.
Timeout(Min.)
Once "Security" is activated to "On", the administrator can set timeout function.
•Press 
or 
to select the timeout interval.
•The range is from 10 minute to 990 minutes.
•When the time is up, the projector will prompt the user to enter the password again.
•The factory default setting of "Timeout(Min.)" is "Off".
•Once the security function is enabled, the projector will request user to enter password when switch on the projector . Both "User Password" and "Administrator Password" can be accepted for this dialogue.
User password
•Press 
to setup or change the "User Password".
•Press number keys to set your password on the remote control and press "MENU" to confirm.
•Press 
to delete character.
•Enter the password when you see "Confirm Password" displayed.
•The password should be between 4 and 8 characters long.
•If you select "Request password only after plugging power cord", the projector will prompt the user to enter the password every time the power cord is plugged.
•If you select "Always request password while projector turns on", the user has to enter the password every time when the projector is turned on.
Note: This screen capture function is limited by 4:3 aspect ratio only.
Note: For XGA models, to get best quality for you desired image, suggest
English
