+FLID=n | Local ID string (TSI/CSI) |
+FMDL? | Request DCE Model |
+FMFR? | Request DCE Manufacturer |
+FPPR: | Partial Page Report Response |
+FPTS: | Receive Page Transfer Status Response |
+FPTS: | Transmit Page Transfer Status Response |
+FPTS=n | Page Transfer Status Parameter |
+FREV? | Request DCE Revision |
3.7 Voice Mode Commands
#VA=m | Enable/disable AGC |
#VAA=n | Select |
#VB=f1,t | Generate beep tone(f1=frequency,t=duration) |
#VBL=n | Sets voice buffer length control |
#VBO=n | Set binary offset mode |
#VBS=n | Specify data transfer via DMA |
#VC | Disable, Enable <DLE><CAN> and DTMF |
| abort |
#VCH=n | Set DMA channel |
#VDR=e,r | Enable distinctive ring detection |
#VD0 | Transmit voice data |
#VD1 | Receive Voice Data |
#VF=n | Set FIFO size |
#VG=n | Gain setting in voice record mode |
#VH=n | Energize relay |
#VL | Set |
#VM=n | Microphone command |
#VNH=n | Set hook behavior for fax and data calls within |
| voice calls |
#VRA=n | Ringback goes away timer |
#VRN=n | Ringback never came timer |
#VSC=n | Set compression mode to n |
#VSD=0,1,2 | Silence deletion control (disable, 1 sec, .5 sec.) |
#VSI=n | Set silence end of message timer |
#VSM=n | Set CODEC mode to n |
#VSn | Activate voice mode (DTE rate n) |
#VSP=n | Set monitor mode |
#VSR=n | Enable actions and/or speakerphone response |
| codes |
#VSS=n | Set sample rate to n |
#VST | Set silence threshold |
#VSV | Transmit voice data, listen for DTMF and |
| CNG |
#VTI=n | Supervision point qualifier |
#VTn | Controls command mode DTMF and CNG |
| detection |
11
