32
English ...
Appendices
Replacing the lamp

The projector will detect the lamp life itself. It will show you a

warning message “Lamp is approaching the end of its useful

life in full power operation. Replacement Suggested!” When

youseethismessage,changingthelampassoonaspossible.

Make sure the projector has been cooled down for at least 30

minutes before changing the lamp.

Warning: Lamp
compartment is hot!
Allow it to cool down
before changing
lamp!
Warning: To
reduce the risk of
personalinjury,do
not drop the lamp
module or touch
the lamp bulb. The
bulb may shatter
and cause injury if
it is dropped.
13
4
2
Lamp Changing Procedure:
1. TurnthepowerofftheprojectorbypressingthePowerbutton.
2. Allow the projector to cool down at least 30 minutes.
3. Disconnect the power cord.
4. Removethecover.
5. Push up and remove the cover.
6. Remove the 3 screws from the lamp module.
7. Pull out the lamp module.
To replace the lamp module, reverse the previous steps.