V76MSE.book Page 18 Wednesday, May 19, 1999 1:25 PM

18Chapter 1 Getting Started

Error Message

Corrective Action

 

 

 

 

Pointing Device Error

Reconnect or replace the pointing

 

 

device.

 

 

 

 

Pointing Device Interface Error

Check the pointing device interface

 

 

circuit.

 

 

 

 

Pointing Device IRQ Conflict

Enter Setup and change the IRQ setting

 

 

of the PS/2 mouse.

 

 

 

 

IDE Drive 0 Error

Replace the disk drive or the HDD

IDE Drive 1 Error

(hard disk drive) controller. Check the

IDE Drive 2 Error

HDD cable connections and IDE

IDE Drive 3 Error

settings in Setup.

 

 

 

 

IDE Drive 0 / 1 / 2 / 3 Auto

Replace the disk drive or the hard disk

Detection Failed

drive controller. Check the HDD cable

 

 

connections and IDE settings in Setup.

 

 

 

 

Floppy Drive A Error

Check if there is no floppy disk in the

Floppy Drive B Error

drive. If there is, turn off the system

 

 

and check the cable connections. If the

 

 

connections are okay and the error

 

 

message continues to show, replace

 

 

the floppy drive.

 

 

 

 

Floppy Disk Controller Error

Check the floppy drive cable and its

 

 

connections. If the cable is good and

 

 

properly connected, the floppy disk

 

 

controller may be the problem.

 

 

Change the floppy disk controller or

 

 

disable the onboard controller by

 

 

installing another add-on card with a

 

 

controller.

 

 

 

 

CPU Clock Mismatch

When the user changes the CPU

 

 

frequency, this message will be shown

 

 

once. Then the BIOS will adjust the

 

 

CPU clock automatically.

 

 

 

 

Serial Port Conflict

Change the onboard serial port

 

 

address in Setup or change the add-on

 

 

card serial port address.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 28
Image 28
Acer SE Pointing Device Error Reconnect or replace the pointing, Check the pointing device interface, Circuit, PS/2 mouse