Setup 6-23
After setting a password, the notebook sets this parameter to [Present].
The next time you boot the notebook, resume from suspend mode, run the
Setup utility or unlock system resources, the password prompt appears.
Key in the appropriate password (Supervisor or User). The system asks for
your password input until you enter the correct password.
If you forget your password, you must reset the configuration values stored
in CMOS to defaults. Resetting CMOS requires opening up the system unit,
so contact your dealer for assistance.
Removing a Password
If you enter Setup using the user password, you cannot modify
or remove the supervisor password.
To remove a password, select the desired password to remove and press z
or x.
6.6.2 Diskette Drive Control
This parameter allows you to enable or disable the read/write functions of
the floppy drive. The following table summarizes the available options.
Table 6-2 Diskette Drive Control Settings
Setting Description
Normal
(default) Floppy drive functions normally
Write-Protect Disables any floppy drive write function. This function protects
all sectors only under DOS mode.
Disabled Disables the floppy drive