- 38 -
5.2 Software / Firmware Upgrade Process 5.2.1 Hardware prepared:
Hardware Requirement:
1. ISP board x 1
2. DSUB VGA cables x 2
3. Printer cable (with one male connector and another female connector) x 1.
4. PC or Notebook with parallel (printer) port x1.
Connect to target monitor
VGA signal input from 15pin D-
sub cable of PC or NB.
Connect ISP board and
PC with printer port
cable
Check the Jumpers on
the ISP Circuit Board
(make sure J5, J6, J7,
J8 are set at ping 1,2 )