Acroprint ATR120 VI. Installing your ATR120

The ATR120 allows for the use of a four-digit number as a password to protect

programmed settings. When the password is set, you will be asked to enter it each

time you enter the programming mode. It is recommended that if a password is used

that you write it down and store it in a safe place. If an incorrect password is entered

you will be prevented from entering the programming mode. Note: If correct

password cannot be entered, the clock can be reset to original settings by pressing

the “RESET” switch on back of clock next to the program switch. Doing so will

reset ALL functions, requiring the ATR120 to be re-programmed.

· Press button one once. If you are entering the programming mode to set or

adjust the password, press button one ten times. The display indicates 00 00.

· Press button four to choose the first two digits of the password. You may use

any digits from 00 to 99. OUT3 flashes in the lower right corner of the display.

· Press button five to choose the last two digits of the password. You may use

any digits from 00 to 99. OUT3 flashes in the lower right corner of the display.

· Press button six one time to save the password setting. The flashing OUT3

disappears.

Once the password has been set, when you enter the program, the ATR120 will

display 0000. The password must be entered and button six pressed, then the time

clock will display and enter program mode. If the password is incorrect, then the

ATR120 will beep and Error Message E-40 is displayed. You will not be allowed to

enter the programming mode until the correct password is entered.

When you have finished programming the ATR120, reset the program switch on the

back of the clock, to the NOR position and press button one once to return to the

normal mode. The ATR120 will now display the current time and date and is ready

for operation.

VI. Installing your ATR120

The ATR120 can be installed in any normal office environment. It may be installed

on a smooth, flat surface or wall-mounted. No special wiring is needed. However,