SETUP SETUP
Remove the battery
compartment cover.
Install 2 fresh “AA”
batteries, as shown.
BATTERIES MUST BE
INSTALLED FOR THE
SENSOR TO OPERATE.
Install Batteries - Outdoor Sensor
Extended periods of cold temperatures (below -4ºF / -20ºC) can cause
alkaline batteries to function improperly. This causes the outdoor sensor
to stop transmitting data. Use lithium batteries in low temperature
conditions to ensure continuous operation of the outdoor sensor.
40
A/B/C Wireless Selection
To allow for more than one weather station and wireless sensor to be
used within close proximity, the display console and outdoor sensor
have a small switch labeled “A B C” within the battery compartments.
This switch allows you to select one of 3 wireless modes.
PLEASE NOTE: Both switches MUST be set in matching positions (either
A, B, or C) for wireless communication.
Install Batteries - Display Console
SWITCH SELECTION
MUST MATCH
DISPLAY UNIT
SWITCH SELECTION
32
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from
equipment which is not to be used for an extended period of time. Follow the polarity (+/-) diagram in the battery
compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same
or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in re, as
batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use
rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
NOTICE!
SWITCH SELECTION
MUST MATCH
WIRELESS SENSOR
SWITCH SELECTION
Remove the battery
compartment cover.
Install 3 fresh “AA”
batteries as shown
here.
NOTICE!