Troubleshooting
| • The backlight may automatically turn off for 10 minutes | |
| at 2:00am and 3:00am to acquire the atomic clock | |
| signal. | |
| • Verify power adapter is plugged in. | |
Clock is too dark, | • Check that the batteries are installed correctly. Batteries | |
may need to be replaced. | ||
hard to read or | ||
• Increase brightness using +/– buttons, located on the | ||
doesn’t work | ||
back of the clock. | ||
| ||
| • The optimum viewing angle for this product is from | |
| slightly above it. | |
| • Reset the unit by pressing the reset button, located on | |
| the bottom of the clock. | |
Inaccurate | • Make sure the clock is placed out of direct sunlight and | |
away from any heat sources or vents | ||
temperature | ||
(see page 7). | ||
| ||
|
| |
Atomic signal or time | For additional troubleshooting, please visit: | |
syncing problems | http://www.nist.gov/pml/div688/grp40/radioclocks.cfm | |
|
|
If your AcuRite product does not operate properly after trying the troubleshooting steps, visit www.AcuRite.com or call (877)
9
