Acu-Rite 615 instruction manual Troubleshooting, Problem, Possible Solution, reception, humidity

Troubleshooting

	Problem		Possible Solution
			• Relocate the display unit and/or the 3-in-1 sensor.
			The units must be within 330 ft (100 m) of each other.
			• Make sure both units are placed at least 3 feet (.9 m)
			away from electronics that may interfere with the wireless
			communication (such as TVs, microwaves, computers, etc).
			• Use standard alkaline batteries (or lithium batteries in
			sensor when temperature is below -4ºF/-20ºC). Do not use
No outdoor sensor			heavy duty or rechargeable batteries. NOTE: It may take
			up to 20 minutes for display unit and sensor to synchronize
	reception
			after batteries are replaced.
		no bars	• Synchronize the units:
			1. Bring both the sensor and display unit indoors and
			remove at least one battery from each.
			2. Make sure the A-B-C switch on both units match.
			3. Reinstall the battery in the outdoor sensor.
			4. Reinstall battery into the display unit.
			5. Let the units sit within a couple feet of each other for
			about 20 minutes to gain a strong connection.
	Outdoor		Flashing of the outdoor temperature may be an indication of
			wireless interference.
temperature			• Make sure the A-B-C switch in the battery compartments of
is flashing or			both the display unit and sensor are switched to the same
showing dashes			letter. You may choose A, B or C; but both units must match
			to sync up.
			• Weather Forecast icon predicts conditions for the next 12
			to 24 hours, not current conditions.
			• Has Learning Mode icon disappeared from the display
Inaccurate forecast			unit? Learning Mode must complete before forecast and
			pressure will be accurate.
			• Allow unit to run continuously for 33 days. Battery removal
			or resetting the display unit will restart Learning Mode.
			After 14 days, forecast should be fairly accurate, however
			Learning Mode calibrates for a total of 33 days.
			• Make sure both the display unit and 3-in-1 sensor are
Inaccurate			placed out of direct sunlight and away from any heat
			sources or vents (see page 9).
temperature or			• Make sure both units are positioned away from moisture
	humidity		sources (see page 9).
			• Make sure 3-in-1 sensor is mounted at least 5 ft off of
			the ground.

14