ADCP-92-063 • Issue 1 • May 2005

3.210/100 Mb/s Module

OptEnet Chassis should already be installed, power supplies installed, and power connections made before installing OptEnet Media Converter with SFP Modules. Media converter module can be safely removed and installed into a powered chassis. Module installation is shown in Figure 3.

20473-A

MEDIA

CONVERTER

MODULE

Figure 3. Installing Media Converter Module

1. Locate the designated slot in the chassis for the module.

Danger: To avoid the possibility of severe and potentially fatal electric shock, never install electrical equipment in a wet location or during a lightning storm.

Caution: Electronic modules can be damaged by electrostatic discharge (ESD). To prevent this, take the following precautions:

•Wear an anti-static-discharge wrist strap while handling modules.

•Place modules in anti-static packing material when transporting or storing them.

•Place modules on an approved, electrically grounded, anti-static mat when working on them.

2.Slide OptEnet media converter into slot and plug it into the connector on the backplane. Modules can be plugged into any empty slot in the chassis. All fiber connectors are mounted in straight retainers. The module is held in place with thumbscrew fasteners.

3.Secure the module in place by tightening the captive thumbscrews on each end. Be sure that they are properly threaded before tightening.

4.If not already installed insert SFP into OptEnet media converter until you hear it click in place.

Page 7

© 2005, ADC Telecommunications, Inc.