ADCP-61-471 • Issue 4 • June 2000 • Section 2: Operation and Maintenance

DLP-573

Page 1 of 6

HLX LOOPBACK CONFIGURATION

Summary: This procedure provides instructions for viewing or editing the loopback configuration for HLXC modules.

Note: A “toggle” field type means the user can press the space bar to view and select the next option that is described; or the user can press the “R” key to view and select the previous option. An “input” field type means the user must type an entry in the field according to the parameters described. A “fixed” field is locked, and cannot be changed by the user.

Note: Edits can be made in the configuration database in one of two ways: 1) If the complete field is highlighted, use the space bar to toggle forward or the “R” key to reverse toggle through the options for that field. 2) If only the first space or the field is highlighted, type in the data that applies to that field.

Note: Edits to the configuration database can be saved after each change in one of two

ways: 1) Press an arrow key and then Enter or Return once; or 2) Press Enter or Return twice after all selections and entries are made in the screen but before leaving the screen. If the entries have been accepted, a message “Configuration Successful… Press Any Key To Continue” appears on the screen.

Note: Press CONTROL-A for help information on moving around and editing fields.

1.Use the arrow or number keys to select Unit Configuration from the Main Menu. Press Enter or Return.

2.Use the arrow or number keys to select HLX Configuration from the Unit Configuration menu. Press Enter or Return. The HLX Configuration menu is shown in Figure 573-1.

3.Use the arrow or number keys to select Loopback Configuration from the HLX Configuration menu. Press Enter or Return. HLX Loopback Configuration screens are shown in Figure 573-2(MPU V5.1 without an HRX), Figure 573-3(MPU V5.1 with one HRX), and Figure 573-4(MPU V5.2 with two HRXs).

4.Starting at the top of Table 573-1and working your way to the bottom, configure the HLX for the group and slot selected.

5.Assign the selections by pressing Enter or Return.

6.Repeat Steps 4 and 5 for each HLX module installed in the chassis.

Stop! You have completed this procedure.

2-232

© 2000, ADC Telecommunications, Inc.