ADC Broadband System 327

ADCP-61-471 • Issue 4 • June 2000 • Section 2: Operation and Maintenance

TAP-102

Page 5 of 11

Table 102-2. HDSL Mon Type Descriptions

MON TYPE	MEANING	LOCATION	DESCRIPTION
FCP	Failure Count Path	NEND, FEND, REPC,	Count of Loss Of Sync Word (LOSW)
		REPR, CRP, RRP*	failures on the HDSL loop.

CVP	Code Violation Path	NEND, FEND, REPC,	Count of CRC errors on the HDSL loop.
		REPR, CRP, RRP

ESP	Errored Second Path	NEND, FEND, REPC,	A second in which one or more CRC
		REPR, CRP, RRP	errors occurred on the HDSL loop, and
			no LOSW defects occurred.

SESP	Severely Errored	NEND, FEND, REPC,	A second in which the number of CRC
	Second Path	REPR, CRP, RRP	errors on the HDSL loop was greater
			than or equal to some user-specified
			value, and no LOSW defects occurred.

SEFSP	Severely Errored	NEND, FEND, REPC,	A second in which one or more LOSW
	Framing Second Path	REPR, CRP, RRP	defects occurred on the HDSL loop.

PA-H	Pulse Attenuation –	NEND, FEND, REPC,	Highest Pulse Attenuation value detected
	High Path	REPR, CRP, RRP	on the HDSL loop within the interval.
			This value is only updated when the
			HDSL loop is active. If the HDSL loop
			has never been activated, this value will
			be set to 0.

SNR-L	Signal-to-Noise Ratio	NEND, FEND, REPC,	Lowest SNR detected on the HDSL loop
	– Low Path	REPR, CRP, RRP	within the interval. This value is only
			updated when the HDSL loop is active.
			If the HDSL loop has never been
			activated, this value will be set to 71.

*For descriptions of locations where thresholds are monitored (such as FEND, NEND, REPC, REPR, CRP, and RRP), refer to Figure 102-7(T1 system), Figure 102-8(HDSL system), Figure 102-9(DLX system), Figure 102-10(ODS2 system), and Figure 102-11(RLX system).

2-304