9
URC-200
When the display shows “MAIN”, you are back in
normal operating mode. Now it’s time to test all
the buttons. If some buttons don’t work, try
repeating steps 1-9, to see if you can improve the
match to your component.
For Example: My Sony TV powered off with TV code
number 139. However the number buttons didn’t work
when I tested them. So, I repeated steps one to ten, using
other code numbers and eventually discovered that when
code number 185 is set, all the buttons work perfectly.
Repeat steps one through nine for each of your
devices. In most systems, you can finish basic
setup in just a few minutes and put all your old
remote controls away.
If you are still missing commands to control any
of your devices, use the Learning Method on the
next page.
10
11