Adder Technology SVMS2-QUAD, SVMS4-DUAL, SVMS4-QUAD oFREDoFRED gg

SmartView Multiscreen Installation and Use Page 35

the factory default states by typing F8F8ff. Use options F5F5ff and

connections.

F1 - Display firmware first digit (Note: F1 is FF followed by 11 NOT ll)

F2 - Display firmware second digit

F3 - Display firmware third digit

F5 - Restore PS/2 mouse function to the currently selected CPU’s mouse port

F6 - Restore IntelliMouse function to the currently selected CPU’s mouse port

F8 - Reset all configurations to factory default settings. An ‘r’ will show briefly on the

display to confirm that the reset has been completed.

There are many situations where unrestricted access to corporate file servers or

sensitive information needs to be controlled. In such circumstances, the SmartView

Multiscreen can be locked away in a room or secure cabinet and controlled

remotely. In this mode typing the keyboard hotkeys together with 'L' will blank the

screen, disconnect the keyboard and mouse from all of the computers and display

‘P’ on the SmartView Multiscreen display. Control can only be regained by typing the

correct password on the keyboard.

To set the password in configure mode, first type ‘P’ then (return). The display on

SmartView Multiscreen will change to show ‘=' and you can then type your

password. The password is not case sensitive and can be any combination of key

strokes, including the function keys, but excluding the (ctrl), (alt), (shift) and (return)

keys. When you have typed in your password type (return) to register it in the stored

memory. Do not worry if you type the password incorrectly, you can always re-enter

configure mode and set the password again. If you have lost the password and the

SmartView Multiscreen is locked, the unit may be unlocked by powering down the

SmartView Multiscreen, entering configure mode at power on (see section 2.6), and

performing a complete reset using the F8 function.

NOTE - The password consists of a combination of key strokes rather like the code

to a safe. The key strokes are not case sensitive and can include all the keys on the

keyboard (except ctrl, alt, shift and enter). Consequently the following 'password'

would be valid:

oFREDoFRED gg