SmartView Multiscreen Installation and Use Page 32
L1 - SmartView Multiscreen only locks on to active ports during autoscanning
(default)
L2 - SmartView Multiscreen locks on to every port in turn during autoscanning
L3 - SmartView Multiscreen powers on in autoscan mode and locks on to active
ports only
L4 - SmartView Multiscreen powers on in autoscan mode and locks on to all ports
T1 - 2 seconds autoscan delay time before switching to next port (default)
T2 - 5 seconds autoscan delay time before switching to next port
T3 - 7 seconds autoscan delay time before switching to next port
T4 - 10 seconds autoscan delay time before switching to next port
T5 - 15 seconds autoscan delay time before switching to next port
T6 - 20 seconds autoscan delay time before switching to next port
T7 - 30 seconds autoscan delay time before switching to next port
T8 - 60 seconds autoscan delay time before switching to next port
Note: Autoscan mode is ended simply by selecting a fixed channel using the
keypad, the keyboard hotkeys or the mouse.
WARNING - Many modern monitors are fitted with automatic power save relays
and will switch off after a few seconds if connected to an inactive PC. If you
are using such a monitor you must not use the L2 feature. Constant switching
on and off of your monitor's relay will eventually damage your monitor.
4.3 Mouse mode and mouse switching of channels
A three button PS/2 mouse or an IntelliMouse can be used to switch channels on the
SmartView Multiscreen. To switch to the next channel, the user simply holds down
the central button or wheel button and presses the left or right hand button to
change the channel (see section 3.6). If the user does not wish to take advantage of
this feature, it can be disabled by selecting U2, U3 or U5. If the third button is being
used to switch the SmartView Multiscreen then it is not available for use with PC
software although the function of an IntelliMouse wheel is not affected.
Consequently in modes U1, U2 and U4 the SmartView Multiscreen reports to the
PCs that a 2 button mouse is connected. If you wish to use the full function of a 3
button mouse or IntelliMouse for your PC software then you should select options
U3 or U5.