III - Safety instructions
GENERAL SAFETY INSTRUCTIONS
WARNING. Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury. The term “power tool” in all of the warnings listed below refers to your
SAVE THESE INSTRUCTIONS
1)WORK AREA
a)Keep work area clean and well lit. Cluttered and dark areas invite accidents.
b)Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes.
c)Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control.
2)ELECTRICAL SAFETY
a)Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk of electric shock.
b)Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded.
c)Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock.
d)Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock.
e)When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock.
3)PERSONAL SAFETY
a)Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury.
b)Use safety equipment. Always wear eye protection. Safety equipment such as a dust mask,
c)Avoid accidental starting. Ensure the switch is in the
d)Remove any adjusting key or wrench before turning the tool on. A wrench or a key that is left attached to a rotating part of the power tool may result in personal injury.
e)Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations.
f)Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts.
g)If devices are provided for the connection of dust extraction and collection facilities, ensure that these are connected and properly used. Use of these devices can reduce
4)POWER TOOL USE AND CARE
a)Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed.
b)Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
c)Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
d)Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
e)Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f)Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
g)Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different form intended could result in a hazardous situation.
5)SERVICE
a)Have your power tool serviced by a qualified repair personnel using only identical replacement parts. This will ensure that the safety of the power tool is maintained.
ADDITIONAL SAFETY RULES FOR ROTARY MOWERS
•Only use this Lawn Mower when a Residual Current Device (RCD) with a tripping current of not more than 30mA is in the circuit.
•If an extension cord is used make sure it is for outdoor use and marked as such. The recommended size
of extension cord is not lighter than 1.5mm2 and a maximum of 10 metres in length.
•Completely uncoil your extension cable before use to prevent overheating and loss of mower efficiency. When tidying away the cable, wind it carefully to avoid kinking.
WARNING. After switching off the machine, the cutting blade continues to rotate for a few more seconds.
•Frequently inspect the condition of the cutting blades. Damaged blades must be replaced immediately. Blunt blades should be sharpened. Follow all the required precautions when replacing the blades.
•Before use check the supply and extension cord for signs of damage or ageing. If the cord becomes damaged during use, disconnect the cord from the supply immediately. DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY.
•Do not use the appliance if the cord is damaged or worn.
•Read the instructions carefully. Be familiar with the controls and proper use of the equipment.
•Keep extension cord away from cutting blades.
•Wear eye and ear protection. Wear dust protection if the mowing action causes the raising of dust or particles.
•Never allow children, infirm people or people unfamiliar with these instructions to use the rotary collect mower.
•Avoid using the mower, while people, especially children and the infirm, or pets are nearby.
•Use the mower only in daylight or good artificial light.
•Do not operate the mower unless the grass box is in place.
•Never operate the mower with a damaged base.
•Never operate the appliance with defective guards or shields, or without safety devices, for example deflectors and/or grass catcher, in place.
•When starting up and when the machine is in operation, keep the cutting section away from all parts of the body, especially the hands and feet.
•Do not start the machine when it is not in the operating position.
•Thoroughly inspect the mower for loose or damaged parts before each use. Do not use the unit until adjustments or repairs are made.
•Use only the manufacturer’s recommended replacement parts and accessories.
•Always disconnect the mower from the mains when leaving it unattended.
•Switch the motor off and pull out the plug when the machine is not being used, being cleaned, being moved from one place to another or when the blades are being changed or adjusted.
•If there is an interruption to the power supply or the extension cable is damaged, switch off the machine immediately and remove the plug from the power point.
•Inspect and maintain the mower regularly. Have the mower repaired only by an authorised repairer.
•If power cord is damaged, only have it repaired or replaced by an authorised service centre.
•Check that all grass cuttings and dirt have been removed from the ventilation vents.
•When not in use, store the mower out of the reach of children and infirm people.
WARNING. In order to reduce the risk, disconnect the plug from the supply power, only use recommended accessories as required, otherwise personal injury may result.
•Do not use the machine to cut grass which is not on the ground. For example, do not cut grass which is on rocks.
•Do not switch on the machine in enclosed or poorly ventilated spaces or in the presence of inflammable and/or explosive substances such as liquids, gasses and powders.
•Always stop the mower and switch off at the mains when cutting is delayed, emptying the grass box or when walking from one cutting location to another.
•Do not cross roads or gravel paths with the machine still running.
•Do not move the machine by pulling on the electrical cable. Always use the handgrip.
•Keep a balanced and stable stance while using the machine.
•Ensure that the area being cut is free from strings, stones and debris. Remove any objects that could be thrown during cutting or could wind around the cutting mechanism.
•If you hit or become entangled with a foreign object, stop the motor and disconnect from the mains immediately to check for damage. Repair any damage before further operation is attempted. Do not operate the mower with loose or damaged parts.
•Do not cut against hard objects. This could cause injury to the operator and damage to the machine.
•Keep your hands, face and feet away from all moving parts.
•If possible, avoid cutting wet grass.
•Exercise proper caution when mowing on sloping ground. Watch your footing and wear
•Never operate the mower barefoot or when wearing open sandals or canvas shoes.
•Do not mow by pulling the machine towards you.
•When mowing, keep the cable away from the mower. Your direction of work should be away from the power point. Mow in straight lines, not in circles.
•Always keep hands and feet away from rotating parts.
•When the machine is not in use, store it in a dry, and high or
•Check the grass catcher frequently for wear or deterioration.
•After use, disconnect the machine from the power supply and check for damage. If you have the slightest doubts, check with an authorised service centre.
•Only use the machine according to the instructions given in this manual.
2 | 3 |
